​The AVN-DIO10 is a Dante  to 3G/HD/SD-SDI Embedder/De-Embedder with PoE (Power over Ethernet) and is the easiest way to connect legacy SDI equipment to a Dante or AES67 Audio-over-IP network. The AVN-DIO10 takes an SDI feed, de-embeds the 16 audio channels and places them on channels 1-16 of the Dante network, mapped using Dante Controller. It simultaneously takes 16 input channels mapped to the device on Dante Controller and re-embeds them onto the SDI output. With Primary and Secondary Dante ports, the DIO10 features both power and data redundancy.
 
Switches on the unit allow embedding of Dante channels onto the SDI output per channel pair and there are two modes of operation: Insert Mode enabled allows embedding to overwrite existing SDI audio selectively per channel pair. Insert Mode disabled clears any incoming audio channels on the SDI output and then allows selective embedding onto the SDI output per channel pair.
 
The unit also features a test tone mode, a web interface for configuration and detailed status checks.

1 x 3G/HD/SD-SDI input.
1 x reclocked 3G/HD/SD-SDI output.
Dual redundant Primary and Secondary Dante network ports using Neutrik EtherCon® Ethernet connectors.
Powered via PoE (Power over Ethernet) with PoE dual redundancy.
Fully Dante compliant device.
AES67 compatible.
Dante Domain Manager compliant.
Web interface for configuration.
Clock, SDI Lock, PoE and Sync LEDs.
DIPSwitch selection of embed channel pairs.
DIPSwitch cover plate to secure selections made.
Overwrite or insert into existing SDI audio groups.
Test tones available on embedded outputs.
SDI audio sample rate support at 48kHz.
All available Dante sample rates supported.
Sample rate conversion of audio between Dante and SDI.
Dante clock domain can be optionally synchronised from the SDI clock.
Supplied with belt-clip, shoulder strap hooks (but not the strap) and underdesk mounting plate.
3 x units rackmount in the AVN-DIORK.


 

Product Page: https://www.sonifex.co.uk/avn/avn-dio...